ABSYNTH 5 Reference Manual – 56
•
Phasecontrol: Sets the phase of the Oscillator. The effect is only audible if a second
Oscillator is active. This parameter is useful when using integer values for frequency ratios
between carrier and modulator, as it is the case in FM.
5.4.6 Ringmod Mode
In Ringmod mode, the signals from the main oscillator and the mod oscillator are multiplied
with one another.
On the Main panel, you nd the same parameters as in Single mode. For more details, please
refer to the section 5.4.3, “Single Mode”, above.
On the Mod panel, the following parameters are available:
•
Balancecontrol: Controls the balance between the oscillators Main and Mod within the
Oscillator’s output signal.
•
WaveformSelector: Click on the Waveform Selector to open a dialog where you can choose
the Waveform for the oscillator (see section 5.3.1, “Waveform Selector and Waveform
Selection dialog”, above for details).
•
FrequencymenuandFrequencycontrol: Enables you to enter the oscillator’s frequency as
a transposition of the played note (Trans), as a relationship (Ratio) with the played note,
as a xed Frequency (Hz) or via a xed MIDI note (Note). See section 5.3.2, “Frequency
Menu and Frequency Control”, above for details.
To Next Page
Loading...
Need help?
General