ABSYNTH 5 Reference Manual โ 117
These three parameters allow you to position the Breakpoint very precisely. You can also
move the Breakpoint with the mouse to determine its amplitude and position directly. You can
move several Breakpoints at the same time by using the Shift-click or by clicking and draw-
ing the selected area above the part of the Envelope that contains the relevant Breakpoint.
Every editing step in๎uences all selected Breakpoints and the parameter amp, abs time and
slope as well as the MIDI and LFO-settings. The absolute time and the adjusted parameter
are displayed below Time control and Amp control.
Envelope with selected Breakpoint
In the illustration above, the envelope modulates the Filter A1 Freq (1) parameter. For this
reason the ๎lter frequency is displayed in the parameter-division of the selected Breakpoint.
Slope determines the wave shape according to the sequence of the Breakpoints. A value of 1
creates a linear progression, and lower values create different exponential sequences (com-
pare with previous picture).
Breakpoint with Slope value of 1
To Next Page
Loading...
Need help?
General