7197 Series II Owner’s Guide Chapter 6: Commands
August 2011
102
Pitch Columns CPI
Standard 44 for 80 mm
paper
15.6
32 for 58 mm
paper
Compressed 56 for 80 mm
paper
20.3
42 for 58 mm
paper
Example:
MSComm1.Output = Chr$(&H1B) & Chr$(&H16) & Chr$(n)
Related Information:
See “Technical Specifications” for descriptions of character pitches (print modes).
Set Character Right-Side Spacing
ASCII: ESC SP n
Hexadecimal: 1B 20 n
Decimal:
27 32 n
Range of n: 0 - 32
Default:
0
Sets the right side character spacing to [n x horizontal or vertical motion units]. Values for
this command are set independently in Standard and Page Mode.
The units of horizontal and vertical motion are specified by the Set Horizontal and Vertical
Minimum Motion Units (1D 50…) command. Changes in the horizontal or vertical units
do not affect the current right side character spacing. When the horizontal or vertical
motion unit is changed by the Set Horizontal and Vertical Minimum Motion Units (1D
50…) command the value must be in even units and not less than the minimum amount of
horizontal movement.
In Standard Mode the horizontal motion unit is used.
In Page Mode the horizontal or vertical motion unit differs and depends on the starting
position of the printable area. When the starting printing position is the upper left or lower
right of the printable area (set by Select Print Direction in Page Mode, 1B 54 n) the
horizontal motion unit (x) is used. When the starting printing position is the upper right or
To Next Page
Loading...
