7197 Series II Owner’s Guide Chapter 6: Commands
August 2011
107
To modify characters in one of the character set variations, such as Rotated Print, select
one of the Rotated Print commands, copy to RAM, then use the Define User-Defined
Character Set command (1B 26).
Cancel User-Defined Characters
ASCII: ESC ? n
Hexadecimal: 1B 3F n
Decimal:
27 63 n
Value of n:
Specified character code
Range of n:
32 - 255
Cancels the pattern defined for the character code specified by n. After the user-defined
character is canceled, the corresponding pattern from Code Page 437 is printed.
Example:
MSComm1.Output = Chr$(&H1B) & Chr$(&H3F) & Chr$(n)
Exceptions:
This command is ignored if n is out of range or if the user-defined character is not defined.
Select or Cancel Emphasized Mode
ASCII: ESC E n
Hexadecimal: 1B 45 n
Decimal:
27 69
Value of n:
0 (bit 0), not selected
1 (bit 0), selected
Range of n:
0 - 255
Default:
0 (bit 0)
Starts or stops emphasized printing.
Example:
MSComm1.Output = Chr$(&H1B) & Chr$(&H45) & Chr$(n)
Exceptions:
Only the lowest bit of n is effective.
Emphasized printing cannot be used with bit-images or downloaded bit-images.
To Next Page
Loading...
Need help?
General
