7197 Series II Owner’s Manual Chapter 2: Setting Up and Using the Printer
10 September 2011
Repacking the Printer
Review the illustrations on the previous two pages to pack the printer.
1. Place receipt paper between the receipt cover and the print head for protection.
2. Place the printer in the plastic bag and foam pack, place the packed printer in the box,
and secure the box with packing tape.
3. If you are sending the printer to NCR for repair, call your NCR-authorized service
representative for instructions on where to send the printer.
Be prepared to answer questions concerning shipping and billing.
Choosing a Location
The 7197 Series II printer takes up relatively little counter space and may be set on or near the
host computer. Make sure there is enough room to open the receipt cover to change the paper.
The illustration shows the actual dimensions of the printer but leaves several inches around
the printer for connecting and accessing the cables.
186.70 mm
(7.35 in.)
145.50 mm
(5.80 in.)
144.90 mm
(5.70 in.)
To Next Page
Loading...
Need help?
General
