NCR 7197 II SERIES - Define User-Defined Characters; Select or Cancel User-Defined Character Set

7197 Series II Owner’s Guide Chapter 6: Commands
August 2011
104
12 Double-wide
13 Single-wide
1B 2D n Underline
Limitation:
In Diagnostic setting, if “Compress Pitch” setting is “Ignore” then setting the Compressed
pitch(Bit 0) using this command will be ignored
Select or Cancel User-Defined Character Set
ASCII: ESC % n
Hexadecimal: 1B 25 n
Decimal:
27 37 n
Value of n:
0= Code Page 437
1= User-defined (RAM character set)
2= Code Page 850
Range:
0 - 2
Default:
0 (Code Page 437)
Selects the character set. When an undefined RAM character is selected, the
Code Page 437 character is used. See the Printing Specification Guide for the character sets.
 Example:
 MSComm1.Output = Chr$(&H1B) & Chr$(&H25) & Chr$(n)
Define User-Defined Characters
Receipt
ASCII:
ESC & 3 c1 c2 n1 d1 ... nn dn
Hexadecimal:
1B 26 3 c1 c2 n1 d1 ... nn dn
Decimal:
27 38 3 c1 c2 n1 d1 ... nn dn