7197 Series II Owner’s Guide Chapter 6: Commands
August 2011
116
Graphics Commands
These commands are used to enter and print graphics data and are described in order of
their hexadecimal codes.
Print Raster Graphics
ASCII:
DC1 n1 … nk
Hexadecimal:
11 n1 … nk
Decimal:
17 n1 … n72
Value of n:
n1 … nk = Data bytes
Range of n:
0 - 255
Value of k:
k = 72 : 80mm, k = 53 : 58mm
Prints one row of data. N1 … nk : bytes describing the line to print.
Example:
MSComm1.Output = Chr$(&H11) & Chr$(05) & Chr$(255)
Exceptions:
Raster graphcs is not avalable in Page Mode
This is only available in 7194 Native Mode and 7197 Series II Native Mode.
Download BMP Logo
ASCII:
ESC (+*.BMP file data)
Hexadecimal:
1B (+*.BMP file data)
Decimal:
27 (+*.BMP file data)
Value:
Maximum width = 576
Maximum height = 512
Enters a BMP file data into RAM or Flash.
This command is used by sending the file data of a monochrome BMP file preceded by a 0
x 1B. The bit map is stored in the printer in the same manner as a down loaded bit image.
To Next Page
Loading...
Need help?
General
