7197 Series II Owner’s Guide Chapter 6: Commands
August 2011
115
Decimal:
27 43 n
Value of n:
0 = not select (Normal code)
1 = selected (Uni-code(UTF-16))
Default:
0 (normal code)
Starts or stops specified by Unicode(UTF-16).
Note: In Unicode mode, characters are specified as follows.
ESC + 1 <nL> <nH> ESC + 0
<nL><nH> can range in value from 0 to 65535. However, the character that can be
specified is limited to an existing character.
Summary of Rotated Printing
The table shows the combinations of Set/Cancel Upside-Down Print, Set/Cancel Rotated
Print (clockwise), and Rotated Print (counterclockwise). Rotated CCW is mutually
exclusive with the other two commands. Unintended consequences may result when
rotated CCW is mixed with other commands.
The samples of the print show only the normal size characters. Double-wide and double-
high characters are printed in the same orientation. They may also be mixed on the same
line.
Upside Down
(1B 7B n)
Rotated CW
(1B 56 n)
Rotated CCW
(1B 12)
Resulting Output
Canceled Canceled Cleared
A
Canceled Set X
C
B
A
Set Canceled X
ABC
Set Set X
C
B
A
X X Set
A
B
C
Note: The following print modes cannot be mixed on the same line:
1. Standard and compressed pitch
2. Vertical (normal) and rotated
3. Right-side up and upside down
4. Single high (normal) and double high
To Next Page
Loading...
