NCR 7197 II SERIES - Page 137

7197 Series II Owner’s Guide Chapter 6: Commands
August 2011
112
Hexadecimal: 1D 21 n
Decimal:
29 33 n
Value of n:
1 - 8 = vertical number of times normal font
1 – 8 = horizontal number of times normal font
Range of n: 00 – 07, 10 – 17, … 70 – 77
Default of n:
0
Selects the character height using bits 0 to 2 and selects the character width using bits 4 to
7, as follows:
Character Width Selection
Hex Decimal Width
00 0 1 (normal)
10 16 2 (two times width)
20 32 3 (three times width)
30 48 4 (four times width)
40 64 5 (five times width)
50 80 6 (six times width)
60 96 7 (seven times width)
70 112 8 (eight times width)
Character Height Selection
Hex Decimal Height
00 0 1 (normal)
01 1 2 (two times height)
02 2 3 (three times height
03 3 4 (four times height)
04 4 5 (five times height)
05 5 6 (six times height)
06 6 7 (seven times height)
07 7 8 (eight times height)
This command is effective for all characters (except for HRI characters).
In Standard Mode, the vertical direction is the paper feed direction, and the horizontal
direction is perpendicular to the paper feed direction. However, when character
orientation changes in 90 degree clockwise-rotation mode, the relationship between
vertical and horizontal directions is reversed.
In Page Mode, vertical and horizontal directions are based on the character orientation.
When characters are enlarged with different sizes on one line, all the characters on the line
are aligned at the baseline.