NCR 7197 II SERIES - Page 187

7197 Series II Owner’s Guide Chapter 6: Commands
August 2011
162
When model1 or model2 selected
n=48,49,50,51
When microQR selected n=48,49,50
Default n:
48
Selects the error correction level for QR Code.
Note:
In MicroQR, it is not printed error correction level='H' at the time of the choice.
'Symbol versionM1' in microQR. please choose error correction level='L'.
QR Code: Store the data in the symbol storage area
ASCII: GS ( k pL pH cn fn m d1…dk
Hexadecimal: 1D 28 6B pL pH cn fn m d1…dk
Decimal:
29 40 107 pL pH cn fn m d1…dk
Range of pL:
4  255, Here 4 ≤(pL + pH 256)≤ 7092
Range of pH:
0 – 27
Value of cn:
49
Value of fn:
80
Value of m:
48
Range of d
0 255
Value of k:
(pL + pH 256) – 3
Stores the QR Code symbol data (d1...dk) into the symbol storage area (RAM).
QR Code: Print the symbol data in the symbol storage area
ASCII: GS ( k pL pH cn fn m
Hexadecimal:
1D 28 6B pL pH cn fn m
Decimal:
29 40 107 pL pH cn fn m
Values of pL,
pH:
pL, pH specify (pL + pH 256) as the number
of bytes after pH (cn, fn, and [parameters]). (pL +
pH 256) = 3 So (pL = 3, pH = 0)