NCR 7197 II SERIES - Page 210

7197 Series II Owner’s Guide Chapter 6: Commands
August 2011
185
m
(Hex)
Function n
(Hex)
Function
55
Ethernet-info default
setting
00
Ethernet information default
setting (Ethernet Model, need
HW reset)
56 Default setting for All 00 ‘EEPROM default setting’ &
‘Ethernet-info default setting’
(need HW reset)
68 USB Type 00
01
02
ION(Epic)
NonION(NHPI)
NonION(PRTR)
7E Compress Pitch
00
01
Enable
Ignore
7F Compatibility Barcode
Length
00
01
Disable
Enable
80 Receipt Print Mode 00
01
02
High Speed Print
High Quality Print
Eco Print
81 Power-On Thermal
Head Failure Detection
Mode
00
01
Off
On
82 Standby mode 00
01
Disabled
Enabled
83 Power-off mode 00
01
02
03
04
05
Disabled
60min
120min
180min
240min
300min
84 Ethernet RTC Protocol
00
01
TCP
UDP
Set the printer configuration specified by m and n. The printer is reset after receiving this
command to activate the configuration setting. If m or n is out of range, this command is
ignored. But the printer waits the data until terminator code “0FFH”.
 Example:
 MSComm1.Output = Chr$(&H1F) & Chr$(&H06)