7197 Series II Owner’s Guide Index
277 Februrary 2012
real time request to printer, GS sequence, 143
recognizing data from the printer, 137
Commands, sending
using BASIC, 62
using DOS, 61
Communication, 61
Communication cables, 8
connecting, 13
ordering, 6
Communication interface. See RS-232C interface
Communication interface modes, 37
Configuring the printer, 35
Connecting cables
cash drawer, 13
communication, 13
power, 13
Connector
cash drawer, 65
RS-232C communication, 64
Consumables. See Paper
Contacting a service representative, 42
—Ｄ—
Data
moving through buffer, 139
Datascope modes
setting, 40
Default code page, 50
Default lines per inch
setting, 42
Density, of print, 189
Diagnostic modes, 40
Diagnostics, 32
knife failure, 40
level 0, 32
level 1, 32
level 2, 58
level 3, 59
paper jam, 40
paper out, 40
printhead over/under temperature, 41
startup, 32
Vendor adjustment, 53
Dimensions, of printer, 10, 189
DIP switches. See Switch settings
Documentation
ordering, 6
DOS
sending commands, 61
Dot patterns, of characters, 191
DTR/DSR protocol, 63
Duty cycle
limitations, 189
—Ｅ—
EEPROM to default settings, 52
Emulation/software options, 41
Environmental conditions, 188
Errors. See Problems
—Ｆ—
Features, 2
Flash download
commands, 180
Flash download commands, 180
—Ｇ—
Graphics
commands, 116
Graphics commands, 116
—Ｈ—
Hardware options, 46
Horizontal positioning commands, 93
—Ｉ—
Installation
choosing location, 10
connecting cables, 13
loading paper, 37
setting switches, 12
turning on the printer, 36
Interface. See RS-232C interface
—Ｋ—
Knife
failure of, 40
—Ｌ—
LED (green) blinking (fast)
what to do, 40
LED (green) blinking (slow)
what to do, 40
LED (green) does not come on
what to do, 40
Level 0 diagnostics, 32
Level 1 diagnostics, 32
asian mode, 43
carriage return usage, 43
color paper option, 39, 41, 45, 48, 50, 51, 52
To Next Page
Loading...
Need help?
General
