7197 Series II Owner’s Guide Index
279 Februrary 2012
Printer function commands, 80
Printer status
commands, 126
Printer status commands, 126
Printhead
thermal, 3
Printhead, thermal
cleaning, 8
over/under temperature, 41
Printing, continuous
limitations of, 189
Problems, 39
contacting a service representative, 42
knife failure, 40
paper jam, 40
paper out, 40
print is light or spotty, 41
printhead over/under temperature, 41
Protocol, RS-232C
DTR/DSR, 63
XON/XOFF, 63
—Ｒ—
Real time
commands, 138
Real time commands, 138
alternate implementation, 138
preferred implementation, 138
using, 138
Receipt station
character dot patterns, 191
print zones, 192
Receipt test modes
setting, 40
Reliability, 189
Repacking printer, 10
Reset, 13
Rotated printing
summary, 115
RS 232 interface
setting, 37
RS 232 interface settings, 37
RS-232C interface, 62
cash drawer connector, 65
communication connector, 64
DTR/DSR protocol, 63
parameters, 66
setting extra options, 67
technical specifications, 63
XON/XOFF protocol, 63
—Ｓ—
Setting switches, 12
RS-232C parameters, 66
Setup mode. See Level 1 diagnostics
Specifications, 187
RS-232C interface, 63
Speed, 62
Supplies
cash drawer, 6
communication cables, 6
paper, 5
power cord, 6
power supply, 6
shipped separately, 8
Switch settings, 12
Switch Settings
RS-232C parameters, 66
—Ｔ—
Technical specifications
RS-232C interface, 63
Testing the printer, 53
Thermal paper
ordering, 5
requirements, 5
suppliers, 5
Thermal printhead. See Printhead
cleaning, 8
print density, 189
Timing, 62
Troubleshooting. See Problems
Turning on the printer, 36
—Ｕ—
User data storage
commands, 166
User data storage commands, 166
Using real time commands, 138
—Ｖ—
Vendor Adjustment, 53
Vertical Positioning Commands, 87
—Ｗ—
Weight, of printer, 189
—Ｘ—
XON/XOFF protocol, 63
To Next Page
Loading...
Need help?
General
