NCR 7197 II SERIES - Page 32

7197 Series II Owner’s Manual Chapter 2: Setting Up and Using the Printer
18 September 2011
4. Reset the printer. See below for information on resetting the printer.
The printer beeps, prints the current configuration, then waits for you to make a
selection from the Main Menu on the printout.
DIP Switch Settings Information
Switch 1 Settings Switch 2 Settings Printer State
OFF (0) OFF (0) On-line Mode (default)
(In Ethernet I/F: Manual IP)
ON (1) OFF (0) Diagnostic Mode
OFF (0) ON (1) Flash Download Mode /
Vendor Adjustment Mode
ON (1) ON (1)
On-line Mode
(In Ethernet I/F : DHCP IP)
Receipt cover
Receipt
DIP Switch
Switch 2 is shown in
the OFF
p
ositio
n
1
2
ON
Bottom
Cover
DIP
Switch