NCR RealScan 7837-3000 - Chapter 8: Utilities; To Add a Test Code I.D. Prefix to All Symbologies; Reset Scanner; Show Software Revision


Chapter 8: Utilities
To Add a Test Code I.D. Prefix to All Symbologies
ThisselectionpermitsyoutoturnontransmissionofaCodeI.D.before
thedecodedsymbology.SeetheSymbologyChart,includedinthe
AppendixAforthesinglecharactercodethatidentifieseach
symbology.Thisactionfirstclearsallcurrentprefixes,thenprogramsa
CodeI.D.prefixforallsymbologies.This
isatemporarysettingthat
willberemovedwhentheunitisreset.Forinstructionsonhowtoreset
yourscanner,refertoResetScanner.
Reset Scanner
Scanningthefollowingbarcodeclearstemporarysettingsinthe
scannerandreturnsscannertonormaloperation.Scanningthisbar
codealsocausesthescannertore‐linktheradio.
Show Software Revision
Scanthebarcodebelowtooutputthecurrentsoftwarerevision,unit
serialnumber,andotherproductinformationforboththescannerand
base.
8
Add Code I.D. Prefix to
All Symbologies (Temporary)