NCR RealScan 7837-3000 - Connecting the Base with Serial Wedge; CTS;RTS Emulation

Chapter 1: Getting Started 1-23

Not drate)isnecessary.

e: Noextraconfiguration(e.g.,bau
CTS/RTS Emulation
Connecting the Base with Serial Wedge
hebaseusesTTLsignallevelstowedgeintoanRS‐232serialnetwork.
Useonlyserialwedgecablestopreventdamagetothebase.Referto
ConnectingtheBasewithRS‐232SerialPortinChapter2tosetthebaud
rateandcommunicationsprotocol.

1. Turnoffpowertothecomputer.
2. Disconnecttheexistingserialcablefromthecomputer.
3. Connecttheappropriateinterfacecabletothebase.
Note: Forthebasetoworkproperly,youmusthavethecorrectcable
foryourtypeofcomput er.



T