NCR RealScan 7837-3000 - Require Output Sequence; Output Sequence Example

3-10 Chapter 3: Output
Require Output Sequence
WhenanoutputsequenceisRequired,alloutputdatamustconformto
atato
isOn/NotRequired,thescannerattemptsto
gettheoutputdatatoconformtoaneditedsequence,butifitcannot,

thescannertransmitsalloutputdatatothehostdeviceasis.
WhentheoutputsequenceisOff,thebarcodedataisoutputtothe
hostasthescannerdecodesit.
Note: ThisselectionisunavailablewhentheMultipleSymbols
Selectionisturnedon.
aneditedsequenceorthescannerdoesnottransmittheoutputd
thehostdevice.Whenit
Output Sequence Example
thisexample,youarescanningCode93, Code128,andCode39bar
codes,butyouwantthescannertooutputCode391st,Code1282nd,
andCode933rd,asshow below.
ote: Code93mustbeenabledtousethisexample.
In
n
N




