NCR RealScan 7837-3000 - Chapter 2: Terminal Interfaces; Terminal ID

2

Chapter 2: Terminal Interfaces
Terminal ID
IfyourinterfaceisnotastandardPCAT,refertoSupportedTerminalsin
Chapter2,and locatethe Termin a lIDnumberforyourPC.Scanthe
TerminalIDbarcodebelow, thenscanthenumericbarcode(s )from
theProgrammingCharttoprogramthescannerforyourte rmina lID.
Scan
Saveto saveyourselection.
Forexample,anIBMATterminalhasaTerminalIDof003.Youwould
scantheTerminalIDbarcode,then0,0,3fromthe,then Save.Ifyou
makeanerrorwhilescanningthedigits(beforescanningSave),scan
theDiscardcodeon
theProgrammingChart,scantheTerminalIDbar
code,scanthedigits,andtheSavecodeagain.

Note: Afterscanningoneofthesecodes,youmustpowercycleyour
computer.