NCR RealScan 7837-3000 - Wand Emulation; Wand Emulation Connection; Wand Emulation Transmission Rate

Chapter 2: Terminal Interfaces 2-15
Wand Emulation
Wand Emulation Connection
TheWandEmulationConnectionbarcodesshouldbeusedifyouwant
tochangetheterminalIDonly
,  withoutchanginganyotherimager
settings.ItisrecommendedtouseWandEmulationPlug&Playbar
codestoprogramyourimagertoemulateawandreader.TheWand
EmulationPlug&Playbarcodeschangeotherparameters,inaddition
tochangingtheterminalID.RefertoWandEmulationPlug&
Playin
Chapter1forfurtherinformation.
InWandEmulationmode,theimagerdecodesthebarcodethensends
datainthesameformatasawandimager.TheCode39Format
convertsallsymbologiestoCode39.
TheSameCodeFormattransmitsUPC,EAN,Code128and
Interleaved2
of5withoutanychanges,butconvertsallother
symbologiestoCode39.2DsymbologiesareconvertedtoCode128.
TheCode39FormatbarcodebelowsetstheterminalIDto61,andthe
SameCodeFormatbarcodesetstheterminalIDto64.




Wand Emulation Transmission Rate
Thetransmissionrateislimitedbytheterminal’sabilitytoreceivedata
withoutdroppingcharacters.Default=25inches/second.