NCR RealScan 7837-3000 - Product Specifications; NCR 7837 Scanner Specifications; Base Station Specifications; Cable Pinout Diagrams

Chapter 1: Getting Started 1-9



Note: Ifyouareoutofrangewhenyouscanabarcode,youreceive
anerrorbeepevenifyoudonothavethealarmset.Youreceivetheerror
tothebaseorthehost.
rammingChart.Defa ult=0.Set
thesoundtypetofit
beepsincethedatacouldnotbecommunicated
Alarm Sound Type
Ifyouhavesettheout‐of‐rangealarmenabled,youmaychangethe
alarmtypeforthescannerorbasebyscanningtheappropriatebar
codebelowandthenscanningadigit(0‐7)barcodeandtheSavebar
codeontheProg
yourapplication.



Data Accumulation Mode
Scanthebarcodesbelowtoturndataaccumulation(batch)modeon
taacc onm oredwhen
thescannerisoutofrangeofth ndtransmittedoncethescanner

andoff.Ifda umulati odeison,barcodedataisst
ebasea
isbackinrange.
