NCR RealScan 7837-3000 - Code 93

Chapter 6: Symbologies 6-9
WhenCheckDigitissettoValidate,butDon’tTransmit,theunitonly
readsInterleaved2of5barcodesprintedwithacheckdigit,butwill
nottransmitthecheckdigitwiththescanneddata.
WhenCheckDigitissettoValidateandTransmit,thescanneronly
readsInterleaved2
of5barcodesprintedwithacheckdigit,andwill
ofthescanneddata.Default=NoCh eckDigi t.transmitthisdigitattheend


Interleaved 2 of
Scanthebarcodesbelowtochangethemessagelength.Referto
MessageLengthonpage6‐2foradditionalinformation.Minimumand
Maximumlengths mumDefault=
80.
5 Message Length
=2‐80.MinimumDefault=4,Maxi

MinimumMessageLength

MaximumMessageLength

Code 93
< Default All Code 93 Settings >