NCR RealScan 7837-3000 - IBM 4683 Ports 5 B, 9 B, and 17 Interface; Wand Emulation Plug & Play

Chapter 1: Getting Started 1-19
Wand Emulation Plug & Play
InWandEmulationmode,theimagerdecodesthebarcodethensends
datainthesameformatasawandimager.TheCode39Format
convertsallsymbologiestoCode39.
TheSameCodeFormattransmitsUPC,EAN,Code128and
Interleaved2of5withoutanychanges,butconvertsall
other
symbologiestoCode39.
TheWandEmulationPlug&Pla yCode39Formatbarcodebelow
setstheterminalIDto61.TheWandEmulationPlug&PlaySame

osettheTransmission
Rateto25inchespersecond,
utputPolaritytoblackhigh,andIdleStatetohigh.(Ifyouwantto
theterminalIDonly,withoutchanginganyotherimager
toTerm inChapter2.
CodeFormatbarcodesetstheterminalIDto64.ThesePlug&Play
barcodesals
O
change
settings,refer inalID


IBM 4683 Ports 5B, 9B, and 17 Interface
follow gandPlay”codestoprogramthe7837
IBM4683Port5B,9B,or17.
the
Scanoneofthe ing“Plu
for
Note: neofthesecodes,youmustpowercycle
workstation.
Afterscanningo