NCR RealScan 7837-3000 - Good Read Delay; Scanner Trigger M Odes; Manual;Serial Trigger, Low Power

Chapter 3: Output 3-3
Good Read Del
Thissetstheminimumamountoftimebeforethescannercanread
anotherbarcode.Default=0ms(NoDelay.)
User-Specified
setthedelay(from0‐30,000milliseconds)by
scanningdigitsnth ogrammingChartatthebackofthismanual,
Save.
ay
Long Delay (1500 ms)
Good Read Delay
Ifyouwanttosetyourownlengthforthegoodreaddelay,scanthe
barcodebelow,then
ePr
thenscanning
Scanner Trigger M
eitherbypressingthetrigger,orusinga
serialtriggercommand(seeTriggerCommandsinChapter10.Whenin
manualtriggermode,thescannerscansuntilabarcodeisread,or
untilthetriggerisreleased.
odes
Manual/Serial Trigger, Low Power
Youcanactivatethescanner