NCR RealScan 7837-3000 - Duration; Open Link Mode; Out-Of-Range Alarm

1-8 Chapter 1: Getting Started

Touseadifferent
scanning
scanner,youneedtoremovetheoriginalscannerby
theUnlinkScannerbarco de.
,
ed.
Ifyouneedtoreplaceabrokenorlostscannerthatislinkedtoabase
scantheOverrideLockedScannerbarcodebelowandplacethat
scannerinthebase.
Thelockedlinkisoverridden;thebrokenorlost
scanner’slinkwiththebaseisremoved,andthenewscannerislink

Open Link Mode
hennewlyshippedordefaultedtofactorysettings,thebaseand
scannerarenotlinked.Byplacingascannerintothebase,they
establishalink.Placinga differentscannerintothebaseestablishesa
W

newlinkandtheoldscannerisunlinked.Eachtimeascannerisplaced
intothe
base,itbecomesthelinkedscanner;theoldscanneris
unlinked.

Out-of-Range A
I yourscannerisoutrangeofthebase,analarmsoundsfromboth
yourbaseandscanner.Toactivatethealarmoptionsforthescanneror
ebaseandtosetthealarmduration,scantheappropriatebarcode
belowandthensetthetime‐outduration(from0‐3000
seconds)by
scanningdigitsonthe rogrammingChart,thenscanningSave.
Default=0sec(noalarm).
larm
Duration
f
th
P