NCR RealScan 7837-3000 - Trigger Commands; Resetting the Standard Product Defaults

Chapter 10: Serial Programming Commands 10-5
[ACK], MIN2[ACK],
MAX60[ACK],
DFT[ACK].
Thisresponseindicatesthatthedevice’sCoda ingEnable
(CBRENA)issetto1,o
the Charac to0,orD mit
theCheckCharacter(C tto0,orNotRequired;
concatenatio (CCT)is abled;
theMinimumMessage )
issetto ters;
theMaximumMessage issetto 
andtheDefaultsetting value.
Trigger Commands
Y andd escannerwithserialtrigger
commands.First,thes tinManual/Serial rigger
Modeeitherbyscanni l/SerialTr debarcode(see
C send SerialM mma d.Once
the  germode,the
trigge ated nd
deactivatedbysending efollowingcomman
A
D SYN U CR
Thescannerscansunti rcodehasbeenre the 
commandissent,orun serialtime‐outh reach (see
ReadTime‐Out(Serial Mode)inChapt adescription,
andtheserialcomman ischapter).
Resetting the Standard Product Defaults
Ifyouarenotsurewha rammingoptions our nner,or
youhavechangedsom ionsandwantthe ettin srestored,
scantheStandardPro ultSettingsb below.
barCod
ron;
Start/Stop ter(SSX)isset on’tTrans ;
K2)isse
n setto1,orEn
Length(MIN
2charac 
Length(MAX) 60characters;
(DFT)hasno
oucanactivate eactivateth
cannermustbepu T
ngtheManua iggerMo
hapter3),orby ingtheManual/ enuCo n
scannerisinserial trig
risactiv a
th ds:
ctivate:SYN T CR
eactivate:
laba ad,until deactivate
tilthe asbeen ed
Trigger er3for
dinth
tprog areiny sca
eopt factorys g
ductDefa arcode
Standard Product Default Settings