NCR RealScan 7837-3000 - Chapter 10: Serial Programming Commands; Conventions


Chapter 10: Serial Programming Commands
Theserialprogrammingcommandscanbeusedinplaceofthe 
programmingbarcodes.Boththeserialcommandsandthe
programmingbarcodesprogramtheNCR7837.Forcomplete
esofeachserialprogrammingcommand,refer
nsoftware.
Conventions

descriptions:
g the actual value you should send as
.
Menu Comman
or
SubTag {Data} [, SubTag {Data}] [; Tag SubTag
{Data}] […] Storage
Prefix Three ASCII characters: SYN M CR (ASCII 22,77,13).
10
descriptionsandexampl
tothecorrespondingprogrammingbarcodeinthismanual.
Thedevicemustbe
settoanRS‐232interface.Thefollowing
commandscanbesentthroughaPCcomportusingterminal
emulatio
Thefollowingconventionsareusedformenuandquerycommand
parameter A label representin
part of a command
[option] An optional part of a command.
{Data} Alternatives in a command.
bold Names of menus, menu commands, buttons, dialog
boxes, and windows that appear on the screen.
d Syntax
Menucommandshavethefollowingsyntax(spaceshavebeenusedf
clarityonly):
Prefix [:Name:] Tag