NCR RealScan 7837-3000 - Output Sequence Overview; Require Output Sequence; Output Sequence Editor

3-8 Chapter 3: Output
Output Sequence Overview
Require Output Sequence
Whenturnedoff,thebarcodedataisoutputtothehostasthescanner
decodesit.Whenturnedon,alloutputdata mustconformtoanedited
sequenceorthescannerdoesnottransmittheoutputdatatothehost
device.
Note: ThisselectionisunavailablewhentheMultipleSymbols
Selectionisturnedon.
Output Sequence Editor
Thisprogrammingselectionpermitsyoutoprogramthescannerto
outputdata(whenscanningmorethanonesymbol)inwhateverorder
yourapplicationrequires,regardlessoftheorderinwhichthebar
codesarescanned.ReadingtheDefaultSequencesymbolprogramsthe
scannertotheUniversalvalues,shownbelow.Theseare
thedefaults.
Becertainyouwanttodeleteorclearallformatsbeforeyoureadthe
DefaultSequencesymbol.
Note: TomakeOutputSequenceEditorselections,youneedtoknow
thecodeI.D.,codelength,andcharactermatch(es)yourapplication
requires.UsetheAlphanumericsymbols(SampleSymbols)toreadthese

options.
To Add an Output Sequence
1. ScantheEnterSequencesymbol(seeMultipleSymbolsinChapter3).
2. CodeI.D.
OntheSymbologyChartinAppendixA,findthesymbology to
whichyouwanttoapplytheoutputsequenceformat.Locatethe
Hexadecimalvalueforthatsymbologyandscanthe2digit
hexadecimalvalue
fromtheProgrammingChartatthebackofthis
manual.