NCR RealScan 7837-3000 - Centering Window

Chapter 3: Output 3-7
Centering Window
Usethecenteringfeaturetonarrowthescanner’sfieldofviewsothe
scannerreadsonlythebarcodeyouwant.Whencenteringisturned
on,thescanneronlyreadscodesthatintersectorarecontainedwithin
thecenteringwindowyousetup.Atleastpartofabarcodemust
be
withinthewindowtobedecodedoroutputbythescanner.
Tochangetheleftorrightedgeofthecenteringwindow,scan
CenteringOn,thenscanoneofthefollowingbarcodes.Thenscanthe
percentyouwanttoshiftthecentering windowusin gdigitsinthe 
Programming
Chartatthebac kofth is manual.ScanSa ve .Defa ult
Centering= 40%forLeft,60%forRight.

CenteringOn
*Centering Off

RightofCenterin gWindow

