NCR RealScan 7837-3000 - IBM Surepos

Chapter 1: Getting Started 1-21
2. ProgramthebasefortheUSBinterface.(SeeConnectingtheBase
withUSB.
ple
Note: Withoutusingthe9‐voltexternalpowersupply,thebaseonly
usesenoughpower
fromtheho sttooperatetheinterface.Thescanner ’s
batteryisnotcha rg ed wheninth is mode.Usingthe 9‐voltexternal
permitsthescanner’sbatterytobecharged,andno
nfromthehost.
IBM SurePos
37
: Afterscanningoneofthesecodes,youmustpowercyclethe
ashregister.
3. 3.VerifythebaseoperationbyscanningabarcodefromtheSam
Symbolsinthebackofthismanual.
powersupply
powerisdraw
Scanoneofthefollowing“PlugandPlay”codestoprogramthe78
forIBMSurePos(USBHandHeldscanner)orIBMSurePos(USB
Tabletopscanner).
Note
c
IBMSu rePos(USBHandHeld
Scanner)Interface


Eachbarcodeabovealsoprogramsthefollowingsuffixesforeach 
symbology:
