NCR RealScan 7837-3000 - Inspecting Cords and Connectors

12-2 Chapter 12: Maintenance
Inspecting Cords and Connectors
Inspectthebase’sinterfacecableandconnectorforwearorothersigns
ofdamage.Abadlyworncableordamagedconnectormayinterfere
withscanneroperation.ContactyourNCRrepresentativefor
informationaboutcablereplacement.
Replacing the Base Interface Cable
1. TurnthepowertothehostsystemOFF.
2. Disconnectthebase’scableformtheterminalorcomputer.
3. Turnthebaseupsidedown.
4. Pulltheconnectoroutwhile
maintainingpressureonthe
connectorreleaseclip.
5. Replacewiththenewcable.Inserttheconnectorintotheopening
and
pressfirmly.Theconnectoriskeyedtogoinonlyonewayand
clickintoplace.