NCR RealScan 7837-3000 - Page 38

1-24 Chapter 1: Getting Started


4. Plugtheserialconnectorintotheserialportonyourcomputer.
Tightenthetwoscrewstosecuretheconnectortotheport.
5. Plugtheotherserialconnectorintotheotherdeviceconnectionand
tightenthetwoscrews.
6. Plugthepowersupplybarrelconnectortothebaseand
plugthe
powersupplyintotheACsource.
7. Oncethebasehasbeenfullyconnected,powerupthecomputer.
Tosetupthe serialwedgetermina lID,usetheserialterminalID050
andfollowtheinstructionsinChapter2.Makesurethatallofthe
communicationparametersmatch
onalloftheconnecteddevices.
ChoosingBothsendsscanneddatatoP1andP2.Default=P1.



