NCR RealScan 7837-3000 - Page 145

Chapter 10: Serial Programming Commands 10-9

Selection
Setting
*
# Indicate
n
apter
Indicates default
Serial
Command
s a
umeric entry
Ch
7 Data, 1 Stop, Parity Even 232WRD3 2
232WRD0 2 7 Data, 1 Stop, Parity None
7 Data, 1 Stop, Parity Odd 232WRD6 2
7 Data, 2 Stop, Parity Even 232WRD4 2
Word Length: Data Bits,
Stop Bits, and Parity
None 7 Data, 2 Stop, Parity 232WRD1 2
y Odd 7 Data, 2 Stop, Parit 232WRD7 2
8 Data, 1 Stop, Parity Even 232WRD5 2
Parity None *8 Data, 1 Stop, 232WRD2 2
ty Odd 8 Data, 1 Stop, Pari 232WRD8 2
*RTS/CTS Off 232CTS0 2
RTS/CTS Mode 2 On 232CTS2 2
*XON/XOFF Off 2 232XON0
RS-232 Handshaking
XON/XOFF On 232XON1 2
*ACK/NAK Off 232ACK0 2
ACK/NAK On 232ACK1 2
Wand Emulation Connec- Same Code Format TERMID64 2
tion Code 39 Format TERMID61 2
10 WNDSPD0 2
1 *25 WNDSPD 2
40 WNDSPD2 2
Wand Emulation Transmis- 80 WNDSPD3 2
sion Rate
120 WNDSPD4 2
150 WNDSPD5 2
200 WNDSPD6 2
*Black High WNDPOL0 2
Wand Emulation Polarity
e High Whit WNDPOL1 2
Idle Low WNDIDL0 2
Wand Emulation Idle
High *Idle WNDIDL1 2
20 WNDBLK0 2
Wand Emulation Data *40 WNDBLK1 2
Block Size 60 WNDBLK2 2
80 WNDBLK3 2

10 - 8