Desktop Repair 5-5
When removing an expansion board from the backside of the ISA/PCI-Bus back-
board separate the inside expansion slot L-bracket from the expansion board by
removing the screw shown in Figure Section 5-7.
Figure Section 5-7 Removing the Expansion Slot L-Bracket
ISA/PCI-BUS Backboard Removal
Remove the ISA/PCI-Bus backboard from the system unit as follows.
1. Remove the top cover and all expansion slot boards as previously described.
2. Remove the two ISA/PCI-Bus backboard screws (see Figure Section 5-7).
3. Lift the backboard away from the bracket and out of the system unit.
Figure Section 5-7 ISA/PCI-Bus Backboard Screws
Screw
Expansion
Board
Bracket
L-Bracket
ISA/PCI-Bus
Backboard
Screws
Bracket
To Next Page
Loading...
