Desktop Repair 5-13
5 1/4-Inch Device Cage Removal
Remove the 5 1/4-inch device cage from the system unit as follows.
NOTE: Devices housed inside the device cage
can be removed from the device cage without
removing the device cage. See the preceding
procedure.
Remove the device cage only when completely
disassembling the system unit.
1. Remove the top cover, front panel, and 3 1/2-inch drive bracket as previously de-
scribed.
2. Unplug the signal and power cables from any installed device(s) in the 5 1/4-inch
device cage (see Figure Section 5-19).
3. Remove the four device cage screws from the front of the device cage (see
Figure Section 5-21).
4. Pull the device cage out from the inside of the system unit. Devices in the device
cage do not need to be removed when removing the device cage.
Figure Section 5-21 5 1/4-Inch Device Cage Screws
Device Cage
Device Cage
To Next Page
Loading...
