2-16 Setup and Operation
To change or delete the password, do the following:
1. Highlight the “Change Password” selection on the Main Menu.
2. Press Enter. An “Enter NEW Password” message appears on the screen. Change
or delete the password, as follows.
Change the password, by entering a new password, then follow steps 3, 4 and
5, above.
Delete the password, by pressing Enter. A “Password Now Disabled” message
appears.
3. Press Enter to return to the Main Menu.
If the password is forgotten, re-position the password jumper on the system board to
disabled (see “System Board Jumpers” later in this section).
Write to CMOS and Exit
This menu option opens a screen that saves the changes to CMOS and exit the Setup pro-
gram. Type y if save and exit the program or y to exit without saving, then press Enter.
Do Not Write to CMOS and Exit
This menu option opens a screen that exits the Setup program and without saving the
changes. Type y if to exit the program and not save the changes, then press Enter. Type n
to return to the program
To Next Page
Loading...
