6-10 Minitower Repair
SIMM Removal
Remove any optional SIMM sticks from the system board as follows.
1. Remove the top cover and any full size expansion boards as previously described.
2. Spread apart the two clips at each end of the SIMM stick (the clips are part of the
system board's connectors). Tilt the SIMM stick forward, allowing the post to
slide out of the hole in the SIMM stick.
3. Remove the SIMM stick from the system board. Repeat step 2 for each SIMM to
be removed.
NOTE: If more detailed information is needed,
see the installation instructions in Section 3,
Options.
Figure Section 6-17 SIMM Socket
Clips
Hole
Post
To Next Page
Loading...
