Desktop Repair 5-7
5. Remove the four 3 1/2-inch diskette drive screws; two on each side of the drive
bracket (see Figure Section 5-11).
Remove the two 3 1/2-inch hard disk drive screws; two on each side of the drive
bracket (see Figure Section 5-11).
6. Pull the drives out from the front of the bracket.
Figure Section 5-11 3 1/2-Inch Diskette and Hard Disk Drive Screws
Front Panel Assembly Removal
Remove the front panel assembly from the system unit as follows.
1. Remove the top cover and 3 1/2-inch drive bracket as previously described.
2. Unplug the following cables from their connectors (see Figure Section 5-13).
n Power lamp (connector J32)
n Hard disk drive busy lamp (connector J33)
n Reset button (connector J31)
3 1/2-Inch
Diskette Drive
3 1/2-Inch
Hard Disk Drive
2 of 4
Diskette
Drive Screws
2 of 4
Hard Disk
Drive Screws
To Next Page
Loading...
