5-12 Desktop Repair
Optional 5 1/4-Inch Device Removal
Remove an optional 5 1/4-inch device from the 5 1/4-inch device cage per Figure Section 5-
19, and the following steps.
1. Remove the top cover, front panel, and 3 1/2-inch drive bracket as previously
described.
2. Unplug all signal and power cables from the device(s) in the 5 1/4-inch device
cage (see Figure Section 5-19).
3. Remove the four device screws; two from each side of the 5 1/4-inch device cage
(see Figure Section 5-19).
4. Remove the device out of the 5 1/4-inch device cage from the front of the
system unit.
NOTE: When reinstalling the 5 1/4-inch device,
note that all power cables are keyed to fit only in
the correct position. The red edge of the diskette
drive signal cable is positioned as shown.
Figure Section 5-19 5 1/4-Inch Device Screws
2 of 4
Device Screws
Power Cable
Signal Cable
Device Cage
To Next Page
Loading...
