NEC POWERMATE P60D - 1;2-Inch Diskette and Hard Disk Drive Removal; Inch Drive Bracket Screws

5-6 Desktop Repair
3 1/2-inch Diskette and Hard Disk Drive Removal
Remove the 3 1/2-inch diskette drive and 3 1/2-inch hard disk drive as follows.
1. Remove the top cover as previously described.
2. Unplug the diskette drive power cable and signal cable from the diskette drive
(see Figure Section 5-9).
3. Unplug the hard disk drive power cable and signal cable from the hard disk drive.
NOTE: When reinstalling the drives, note that
all power cables are keyed to fit only in the cor-
rect position. The red edge of the diskette drive
signal cable is positioned as shown.
4. Remove the four 3 1/2-inch drive bracket screws (see Figure Section 5-9).
Figure Section 5-9 3 1/2-Inch Drive Bracket Screws
Red Edge
Diskette Drive
Signal Cable
Hard Disk Drive
Signal Cable
1 of 4 Drive
Bracket Screws
3 1/2-Inch
Drive Bracket
Diskette Drive
Power Cable
Hard Disk Drive
Power Cable