6-14 Minitower Repair
4. Remove the two screws holding the device cage to the chassis support bracket
(see Figure Section 6-16).
Figure Section 6-16 Removing 3 1/2-Inch Drive Cage Screws
5. Remove the 3 1/2-inch drive cage from the chassis.
6. Remove the hard disk drive from the 3 1/2-inch drive cage; two on each side (see
Figure Section 6-18).
Figure Section 6-18 3 1/2-Inch Hard Disk Drive Screws
Screws
Screws
3 1/2-Inch
Drive Cage
Chassis Support
Bracket
2 of 4 Screws
Hard Disk
Drive
3 1/2-Inch
Drive Cage
To Next Page
Loading...
