NEC POWERMATE P60D - System Board Connectors and Screws

5-16 Desktop Repair
2. Remove and label all cables connected to the system board Figure Section 5-27
provides the general locations of the connectors for the system board. Appendix
A provides the pin assignments for each connector; Table Section 5-3 identifies
the correct connector.
3. Remove the seven screws that hold the system board to the system unit chassis
(see Figure Section 5-27). Remove the system board out the side of the system
unit.
Figure Section 5-27 System Board Connectors and Screws
Table Section 5-3 Connector Identifiers
Connector Function Connector Label
Power supply connector J12
PCI IDE hard disk drive connector J22
Standard IDE connector (not used) J23
Diskette drive connector J24
Fan connector J29, J30
Speaker connector J37
Power lamp connector J32
Hard disk drive busy lamp connector J33
Reset button connector J31
Speaker
Connector
Power Lamp
Connector
Hard Disk
Drive Busy
Connector
Standard IDE
Connector
Diskette Drive
Connector
Power
Connector
1 of 9
Screws
Reset
Connector
PCI/IDE
Connector