Setup and Operation 2-15
Table Section 2-4 Peripheral Management Setup Parameters
Parameter Options Description
Second Serial
Port Address
Disabled
2F8H
2E8H
Default is Disabled. The address is automatically set to 2F8H
in the Programming Option, above.
Parallel Port
Address
Disabled
378H
278H
3BCH
Default is Disabled. The address is automatically set to 378H
in the Programming Option, above.
Parallel Port
Mode
Normal
Extended
EPP
Default is Normal. The Normal option sets the port to operate
in the AT-compatible mode. Selecting Extended sets the port
to operate in the bi-directional PS/2-compatible mode.
Configure With BIOS Defaults
This menu option opens a screen that loads the BIOS setup default values from the ROM
table. Type y to load the values or n to not load the values, then press Enter.
Configure With Power-On Defaults
Selecting this menu option opens a screen that loads the power-on default values from the
ROM table. Type y if to load the values or n to not load the values, then press Enter.
Change Password
This menu option opens a screen that sets, change or delete a password. Once a password is
set, the Setup program cannot be entered without entering the password.
To set a password, do the following:
1. Highlight the “Change Password” selection on the Main Menu.
2. Press Enter. An “Enter NEW Password” message appears on the screen.
3. Type in the password using up to six ASCII characters.
4. Press Enter. Reenter the password to confirm it. A “Password Now Enabled”
message appears on the screen.
5. Press Enter. Setup returns to the Main Menu. The password is now in effect.
To Next Page
Loading...
