Options 3-35
Minitower 3 1/2-Inch Drive Placement
Install the hard disk drive into the 3 1/2-inch drive cage as follows.
1. Remove the top cover, front panel, and 3 1/2-inch drive cage as previously
described.
2. Install the drive in an open bay in the drive cage. Be sure that the drive connectors
are facing the inside of the chassis when reinstalled.
3. Align the hard disk drive mounting holes with the mounting holes in the device
cage (see Figure Section 3-44).
4. Secure the drive in the drive cage with the four screws (two on each side)
provided with the drive.
Figure Section 3-44 Securing the Drive in the 3 1/2-Inch Drive Cage
2 of 4 Second
3 1/2-Inch
Drive Cage
Hard Disk Drive
Screw Holes
To Next Page
Loading...
