3-28 Options
2. Locate the power connector coming from the power supply and plug correct fit-
ting power cable into the device power connector (see Figure Section 3-30).
Figure Section 3-30 Desktop 5 1/4-Inch Diskette Drive Cables
Desktop Hard Disk Drive Cabling
Cable the hard disk drive as follows.
1. Locate the IDE hard disk signal cable (connected to the 3 1/2-inch hard disk
drive) and plug the middle connector into the signal connector on the hard disk
drive in the 5 1/4-inch slot (see Figure Section 3-32).
NOTE: When installing the drives, note that all
power and hard disk signal cables are keyed to fit
only in the correct position.
Either of the hard disk drive signal cable connectors may be used for the hard disk
drives. The hard disk drives are configured by jumpers as master (drive C) and
slave (drive D). The hard disk drive connectors are identified in Figure Section 3-
20.
1.2-MB Diskette
Drive Connector
Red Edge
Diskette Drive
Signal Cable
Power Cable
To Next Page
Loading...
