Options 3-25
Desktop Blank Panel Removal
Remove the front panel assembly from the desktop chassis as follows.
1. Remove the desktop cover and 3 1/2-inch diskette drive bracket as previously
described.
2. Unplug the following cables from their connectors (see Figure Section 3-24).
n Power lamp (connector J32)
n Hard disk drive busy lamp (connector J33)
n Reset button (connector J31)
3. Remove the five front panel screws (see Figure Section 3-24).
4. Feed the lamp and reset cables through the hole in the front of system unit chassis
when removing the front panel assembly.
Figure Section 3-24 Indicator Panel Connectors
Blank Panel
Front Panel
Five Screws
(behind front panel)
Lamp and
Reset Button
Connectors
(not shown)
To Next Page
Loading...
