Setup and Operation 2-5
Minitower Setup
Set up the minitower systems by making the following connections. (See the preceding sub-
section, Desktop Setup, if setting up a desktop computer).
1. At the rear of the system, set the voltage selector switch to 115V or 230V and
insert the power cord into the power socket (see Figure Section 2-6).
CAUTION: The correct AC input voltage must
be properly set. Select the appropriate voltage
with the voltage selector switch located at the
rear of the system.
Figure Section 2-6 Minitower Voltage Selector Switch
System Power
Socket
Voltage Selector
Switch
To Next Page
Loading...
