2-4 Setup and Operation
The system has a built-in checking program that automatically tests the components at
power-on. One beep indicates that the system has successfully completed its power-on test.
If there is a problem, a series of beeps may occur. If this happens repeatedly after powering
on the system, power off the system and see Section 4 for troubleshooting.
NOTE: If the system displays a message
indicating that system settings have changed, run
Setup (see “System Configuration” later in this
section).
If a problem occurs, and is not indicated by beeps, check the following items, then turn to
Section 4 for troubleshooting. Check that:
n the power switch for the system unit and monitor are on.
n all cables and power cords are tightly connected.
n the electrical outlet is working.
n the monitor's brightness and contrast are adjusted properly.
n all options are properly installed (see Section 3 for option installation).
To Next Page
Loading...
