2-2 Setup and Operation
Desktop Setup
Set up the desktop systems by making the following connections. (See the following sub-
section, Minitower Setup, if setting up a minitower computer).
1. At the rear of the system, set the voltage selector switch to 115V or 230V and
insert the power cord into the system power socket (see Figure Section 2-1).
CAUTION: The correct AC input voltage must
be properly set. Select the appropriate voltage
with the voltage selector switch located at the
rear of the system.
Figure Section 2-1 Desktop Voltage Selector Switch
System Power
Socket
Voltage Selector
Switch
To Next Page
Loading...
