Appendix A
Connector Pin Assignments
This appendix describes the system board connector pin assignments. Figure Appendix A-1
shows the locations of the system board connectors. Table Appendix A-1 identifies the con-
nector function with the connector number. Descriptions of the connectors are provided in
the following subsections. Jumper settings are provided in Section 2, Setup and Operation.
Figure Appendix A-1 System Board Layout
Speaker
Connector
Power Lamp
Connector
Hard Disk Drive
Busy Connector
Reset
Connector
Fan
Connector
SIMM Sockets
Fast IDE
Connector
(primary)
Standard IDE
Connector
(secondary)
Diskette Drive
Connector
Power
Connector
J12
ISA/PCI-Bus
Backboard
Connector
Keyboard Port
Mouse Port
Serial Port 2
Serial Port 1
Parallel Port
VGA Monitor
Connector
To Next Page
Loading...
