3-12 Options
4. Insert the OverDrive processor by aligning the notch corner with inner alignment
hole of the socket (see Figure Section 3-22).
Figure Section 3-22 OverDrive Processor Alignment
5. Set the jumper settings for the installed OverDrive processor (see Section 2,
Setup and Operation).
6. Replace any removed expansion boards.
7. Replace the top cover and run Setup to reconfigure the computer for the Over-
Drive processor (see Section 2, Setup and Operation).
Alignment
Dot
Notched
Corner of
Chip (heatsink
not shown)
To Next Page
Loading...
